Add：No. 32, Jiuandong Road, Jiuli Industrial Zone, Shangwang Street, Ruian City, Wenzhou City, Zhejiang Province
Contact：MR.Li
E-mail： wzxhjx2022@163.com
News Center
Home >> News Center
Bubble film machine operation process and inspection should pay attention to the problem
2023/2/18
Bubble film machine is a well-known packaging artifact in the rapid development of express industry. As more and more people see the business opportunities in this industry, there have been a lot of entrepreneurial bubble film machine manufacturers in recent years, and the demand for bubble film machine is growing. Many manufacturers may not be familiar with the use of bubble film machine steps, today to share.
Correct operation process of bubble film machine:
1. Before starting, the temperature in each temperature zone must be raised to the specified requirements according to the process requirements and kept for more than 30 minutes before starting. Do not start the bubble film machine before the temperature does not meet the requirements, so as not to damage the bubble film machine.
2. The products produced by bubble laminating machine are moisture-proof, shock-proof, sound-proof, beautiful, insect-proof, mildew proof and cheap. Therefore, when feeding in the hopper, it is necessary to keep clean and strictly prevent metal debris, sand and small tools from entering the feeding port, so as not to damage the cylinder and screw. If any abnormal noise is found during operation, stop and deal with it immediately.
3. Check whether the temperature control of the bubble film machine is good, whether the heating device is in good condition, and whether the temperature of each point is within the target range to ensure the normal operation of the machine.
4. Observe whether the thickness of the film is uniform and whether the folding diameter meets the standard. If not, it needs to be replaced.
5. Regular maintenance, thoroughly cleaning the bubble film machine every three months, every three months to replace all kinds of bearing grease.
So, before the production of bubble film machine equipment, we need to check and do a good job to ensure its good condition. What should we pay attention to when checking the bubble film machine?
1, check whether the temperature control and heating appliances are in good condition, pay attention to timely adjust the heating temperature of each point within the range of indicators. The pressure of the reservoir should not be too high, but there should be a reserve pressure.
2. Check and control raw material proportion, stir evenly, traction speed, and control film thickness.
3. Regularly check the temperature rise and mechanical transmission of the motor running Kunming bubble film machine, as well as the lubrication of the reducer and air compressor cylinder oil.
4. Check whether the raw materials have impurities, especially the iron mixed with magnets should be checked in time.
5. Observe and adjust the uniformity of film thickness, and the folding diameter meets the standard. When the die exit of the bubble laminating machine is uniform, you can wear gloves and slowly lift the tube blank. At the same time, the end of the tube blank is closed, and a small amount of compressed air is fed into the center hole of the mandrel. It is then carefully guided through the bubble stabilizer and the miter plate, through the traction roller and the guide roller until it is wound. Only in this way can we make better use of Kunming Bubble laminating machine, extend its service life and create more profits.